Quick Answer: How Do You Tell If Your Well Is Contaminated?

Can you drill an existing well deeper?

Well Deepening: Reentering an existing well and drilling to a deeper reservoir.

Well deepening is re-drilling into an already existing well in order to find a deeper more productive reservoir.

Sometimes a previously unproductive well can be deepened in order to reach a location with higher flow and temperature..

How does drinking water get contaminated?

Pesticides and fertilizers can be carried into lakes and streams by rainfall runoff or snowmelt, or can percolate into aquifers. Human and animal waste. Human wastes from sewage and septic systems can carry harmful microbes into drinking water sources, as can wastes from animal feedlots and wildlife.

How long does it take a well to refill?

Wells are usually refilled by rain water, so it would be dependent on how much and how often the well is supplied with water and how many homes are tapped into the same underground well. It can take 1 hour to 1 year.

Why is my well water dirty?

One of the most common dirty well water causes is the presence of manganese and iron in the water. One source of these metals is seeping in from the rock around the well. If you have iron pipes entering your home, they can be a source of these metals if they are rusting.

How do you know if your well is getting low?

Warning Signs your Water Well may be Running DrySIGNS YOUR WELL HAS RUN DRY. Your property’s water well may be suffering from drought conditions and drying up if you notice one of these common symptoms:A Change In Taste. … Murky or Muddy Water. … Pump Runs Longer. … Faucets Begin Sputtering. … Neighbors Also Report Water Problems. … HOW TO FIX A DRY WELL. … HELPFUL TIPS.More items…

What do you do if well water is contaminated?

If your well has been contaminated or you suspect that it may be contaminated, DON’T drink the water. Contact your local, state, or tribal health department for specific advice. You need to properly disinfect or treat the water and have it tested before drinking/using the water!

Can you fix a contaminated well?

How to Fix Well Water Contamination Problems Immediately. If you find that your well water is polluted, fix the problem as soon as possible. You may need to disinfect your water have a new well drilled, re plumb or repair your system. Consider hooking into a nearby community water system (if one is available).

Will boiling well water kill bacteria?

You can boil the well water for 5 minutes. With this, all the bacteria inside it will be eliminated. However, boiling will not be able to remove the solids and other materials inside the well water. The use of chlorine drops or iodine tablets can effectively kill the bacteria in the well water.

How do I know if my well is contaminated?

Smell Signs to Look Out For One of the easiest ways to determine if your water is contaminated is by the smell of rotten eggs. A rotten egg smell points to sulfur bacteria or hydrogen sulfide gas in your water. Sulfur bacteria are naturally occurring.

Can well water go bad?

Although properly stored public-supply water should have an indefinite shelf life, replace it every 6 to 12 months for best taste. If the water you are storing comes from a private well, spring, or other untested source, purify it before storage to kill pathogens (see below).

How long do well pumps last?

15 yearsWhen properly taken care of, a submersible well pump can have a long life of up to 15 years, although it can be difficult to know just how old your well pump is if a previous homeowner had it installed. The above-ground jet pumps that are more commonly used with shallow wells have an average life span of 10 years.

What would cause a well to stop working?

Your well pump may have stopped working due to lack of power. Sometimes resetting a breaker or replacing a fuse affected by a power surge or brownout can fix this. If the well pump circuit breaker has tripped, the well pump itself may be failing.

Why is my well water sputtering?

Sputtering, splashing water from the faucet, even briefly, often means that air is in the pipes or coming into your well pump. … When the water level gets low, the well pump will draw air in as well as water, leading to the sputtering at your water fixtures.

How do you diagnose a well problem?

Here are some warning signs of well and pump problems and how to address them.Common Symptoms.No water. The most basic problem, of course, is no water in the house. … Sputtering water. … Cloudy or muddy water. … High utility bills. … Poor tasting (or smelling) water. … Pressure switch problems. … Pulling and Replacing a Pump.More items…•